Building a stone patio brick that will last the life of your home does not have to be a difficult process. Using a base of sand instead of a concrete slab reduces the complexity of building their greatly patio. Not only you save effort, save time, without diminishing the stability and durability of the surface patio. With the right setup, you can complete the construction of the yard in one day.
- Decide on the overall look of your patio. It has a wide variety of sizes and colors of brick. Measure the size of your patio site to determine the area to cover and buy enough bricks to cover the area with an additional 10% in case of breakage and have some left for later replacements. Creating the size of your yard to contain many whole bricks as possible to avoid waste. Draw the pattern of purposeful design on a piece of paper to scale to facilitate sit on the patio.
- Place lawn flags around the perimeter of your yard to mark the edges of the proposed excavation.
- Dig the hole for the foundation of your yard to a depth of four inches with a shovel. Compress the floor of the hole with a plate compactor so its foundation is a company as possible. Rent a plate compactor rental shop store or home improvement equipment for use.
- Pour a layer of gravel in the hole an inch deep as the basis for the yard drainage. Go on gravel with the compressor to compress the gravel level. Level gravel to create a slope away from the foundation of the structures near the courtyard, so that the water drains away. Create a surface that tracks an inch every eight feet of surface patio.
- Pour a layer of sand in the hole an inch deep, cover the gravel. Sand level with a table of hearth after installation slope with gravel below. Veneer drag along the surface of the sand that even the Board working on a new movement to and.
- Place the bricks for the patio to the sand foundation, placing them at the surface level of the sand. Place the bricks so that butt joints, starting in one corner of the yard or to the side of a structure and work your way to the outer edge of the patio. Cut bricks when necessary adjustment using a circular saw with a saw blade attached mason.
- Place an edge paver clamp around the edges of the yard to create a line between the patio and lawn. Push restricting edge tightly against the edge of the courtyard and then the edge with 10-inch steel spikes driven through the edger on the ground instead of anchor.
- Sweep sand between the bricks to fill the joints between. Use a broom to push the polymeric sand into the joints between the bricks. Polymeric sand has an added binder which hardens the sand creating a more durable surface.
- Place a urethane pad on the patio surface, covering the bricks and compact with compactor plate. S pad protect the bricks from damage during compaction sand standing on boards and bricks placed firmly in the sand Foundation. Renting a place pad rent the compressor.
- Sweep the bricks again to ensure that the joints filled with sand and to remove the sand from the surface of the bricks. Wash the yard with water to clean any remaining sand and activate the hardener. Multiple uses of water may be necessary in accordance with the manufacturer of sand.